Juniper-systems Allegro DOS Manual Bedienungsanleitung PDF herunterladen (Seite 195)

MS-DOS Page 5-35

Startup Files

AUTOEXEC.BAT and CONFIG.SYS startup files containing default

configuration information are factory installed on the C: drive of the

Allegro. Each time you turn on or reboot into DOS on the Allegro, DOS

searches for these files and carries out their commands.

(Note: If the Allegro is booted from the A: drive, the CONFIG.SYS and

AUTOEXEC.BAT files on C: are not executed.)

❖ Important Note: It is important that the existing CONFIG.SYS and

AUTOEXEC.BAT files located on the Allegro's C: drive are not replaced. If

you need to change these files for your application, carefully follow the

directions given in the Startup File section.

CONFIG.SYS File

The CONFIG.SYS file is a text file that contains special commands that

configure the Allegro’s hardware components. DOS starts, it carries out

the commands in the CONFIG.SYS file. The CONFIG.SYS file is located

in the root directory of drive C:.

The following commands can be used only in the CONFIG.SYS file:

Buffers Files

Country Install

Device Lastdrive

Devicehigh Numlock

Dos Shell

Drivparm Stacks

Fcbs Switches

The following commands are commonly used in the CONFIG.SYS file

and can also be typed at the command prompt:

Break

Rem

Set

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 273 274

Keine Kommentare

Juniper-systems Allegro DOS Manual Bedienungsanleitung Seite 195