Juniper-systems Allegro DOS Manual Bedienungsanleitung PDF herunterladen (Seite 175)

MS-DOS Page 5-15

<F4> MkDir: This command is used to create a new subdirectory in the

current directory path. When <F4> is pressed, you are asked to enter the

name of the new subdirectory on the second status line. Enter the name

and press <ENTER>.

<F5> Xfer: Use this function to set up communication parameters and

establish communication between the Allegro and another computer.

When you press <F5> the following communication functions are

shown:

Function Description

F1 = COM Port Set Up Communication Port

F2 = Baud Select Baud Rate

F3 = Cmd Access the Commands

F4 = Recv Receive Files From PC

F5 = Send Send Files to PC

F6 = Lynx Toggle Lynx On and Off

Refer to Establishing Communication Between Computers and

Communicating with Other PC Programs earlier in this section for details

about these functions.

<F6> Move: This command moves a file or a group of files to other

drives or directories. Highlight a file or mark a group of files to be

copied using <Ins> and press <F6>.

You are asked to enter the destination for the files to be moved to on the second

status line. Enter the destination path (drive and directory). Press <ENTER> to

move the file(s).

❖ Note: You cannot move files to the ROM drive (A:)

<F7> Rename: To rename a file, highlight the desired file and press

<F7>. Enter the new filename and press <ENTER>. If you do not want a

filename to have an extension, type the filename ending with a period.

For example, “MYFILE.” would be listed in the directory without an

extension.

<F8> Mark All: Marks all the files on the current directory.

<F9> Unmark All: Unmarks all the files on the current directory.

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 273 274

Keine Kommentare

Juniper-systems Allegro DOS Manual Bedienungsanleitung Seite 175