Juniper-systems Allegro DOS Manual Bedienungsanleitung PDF herunterladen (Seite 89)

Allegro DOS Owner’s Manual 89

Startup Files

AUTOEXEC.BAT and CONFIG.SYS startup ﬁ les containing default

conﬁ guration information are factory installed on the C: drive of the

Allegro. Each time you turn on or reboot into DOS on the Allegro,

DOS searches for these ﬁ les and carries out their commands.

(Note: If the Allegro is booted from the A: drive, the CONFIG.SYS

and AUTOEXEC.BAT ﬁ les on C: are not executed.)

❖ Important Note: It is important that the existing CONFIG.SYS and

AUTOEXEC.BAT ﬁ les located on the Allegro's C: drive are not replaced.

If you need to change these ﬁ les for your application, carefully follow the

directions given in the Startup File section.

CONFIG.SYS File

The CONFIG.SYS ﬁ le is a text ﬁ le that contains special commands

that conﬁ gure the Allegro’s hardware components. DOS starts, it

carries out the commands in the CONFIG.SYS ﬁ le. The CONFIG.SYS

ﬁ le is located in the root directory of drive C:.

The following commands can be used only in the CONFIG.SYS ﬁ le:

Buffers Files

Country Install

Device Lastdrive

Devicehigh Numlock

Dos Shell

Drivparm Stacks

Fcbs Switches

The following commands are commonly used in the CONFIG.SYS

ﬁ le and can also be typed at the command prompt:

Break

Rem

Set

The following special CONFIG.SYS commands are used only to

deﬁ ne multiple conﬁ gurations within the CONFIG.SYS ﬁ le. For more

information about deﬁ ning multiple conﬁ gurations, refer to the DOS

help in the Lynx Help menu.

Include

Menu color

Menudefault

Menuitem

Submenu

▲

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 165 166

Keine Kommentare

Juniper-systems Allegro DOS Manual Bedienungsanleitung Seite 89